Makita BTD133 Technical Information page 10

W
iring diagram
Fig. D-2
Put the extra portion of
Controller's Lead wires for
connecting to Stator in this area.
Do not put any Lead wires
on the ribs of housing set.
Fuse
rib
Tightening the Lead wires in this area,
fix them with Lead wire holders.
Lead wire holder
Stator
Stator
Switch
rib
Controller
LED circuit
Cut the lead wires (blue, white and orange)
at the place surround ribs and screw holes, and then
connect Stator set/Controller set with the cutting ends
of the lead wires when Stator or Controller is necessary
to be replaced. Refer to Fig. D-1.
Connector of
LED circuit
Connector of
Controller
Terminal
LED circuit
Housing
set (L)
Fit the corner of LED circuit
to that of Housing set (L)
Connector of Controller
for connecting to Switch
Put the following parts in this area
surround ribs.
* Fuse
* Connectors of Controller and
LED circuit
* All of the Lead wires of Controller
P 10/ 10