Operation; Adjust Cleaning Temperature; Set Working Pressure And Flow Rate; Turning On The Appliance - Kärcher HDS 551 C Eco Manual

Hide thumbs Also See for HDS 551 C Eco:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 24

Operation

Danger
Lengthy operation of the unit can lead to vi-
bration-related circulatory disturbances of
the hands.
A generally valid use duration cannot be
specified, since this is dependent upon se-
veral influence factors:
– Personal predisposition to bad circulati-
on (frequent suffering from cold fingers,
pins and needles in fingers).
– In low ambient temperatures. Wear
warm gloves to keep hands warm.
– Gripping tightly impedes circulation.
– Continuous operation is more detrimen-
tal than operation interrupted by breaks.
We recommend a medical examination if the
unit is regularly used for extensive, conti-
nuous operation and the corresponding
symptoms (such as, for example, pins and
needles in fingers or cold fingers) are recur-
rent.
Warning
Never operate device with empty fuel tank.
The fuel pump will otherwise be destroyed.

Turning on the Appliance

Figure 2
è Set the appliance switch (1) to "I".
Indicator lamp ready status (4) glows.
Note
If the indicator lamps (2), (3) or (6) are li-
ghting up during operation, turn off device
immediately and repair malfunction, refer to
malfunctions.
The device starts briefly and turns off, as
soon as the working pressure is reached.
Figure 6
è Release the hand spray gun (A).
When activating the hand spray gun the de-
vice switches back on.
Note
If no water comes out of the high pressure
nozzle, vent pump. Refer to malfunctions
"Device is not building up pressure".

Adjust cleaning temperature

è Set device switch to desired tempera-
ture.
30 °C to 90 °C
– Clean with hot water.
100 °C to 150 °C
– Clean with steam (with steam nozzle
4.766-023, HDS 558.../698.../798...only).

Set working pressure and flow rate

HDS 558.../698.../798...only
Servo pressure regulation
è Set device switch to max. 98 °C.
Figure 7
è Set regulating spindle to maximum wor-
king pressure.
Figure 6
– Set working pressure and flow rate
through turning (rungless) at the pressu-
re- and amount regulation (B) (+/-).
Note
For long term work with low pressure, set
pressure at device. See Figure 7.
Dose of detergent
– For considerate treatment of the environ-
ment use detergent economically.
– The detergent must be suitable for the
surface to be cleaned.
HDS 558.../698.../798...only
Figure 1 - Pos. 8
è With support of the detergent dose valve
set detergent concentration as determi-
ned by the manufacturer.
0 = work without detergent
27
English

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hds 558 c/csx ecoHds 698 c/csx ecoHds 798 c/csx eco

Table of Contents