Massage Chair - European Touch sogno dreamwave Owner's Manual

Massage chairs
Table of Contents

Advertisement

FUSE
The Spa's fuses keep blowing
1) Remove the Metal cover
2) From the gray control box disconnect the MB2, 12vac and 21vac transformer, and PDP
3) Plug the unit into power source (with everything but the motor disconnected)
4) Plug MB2, 12vac and 21vac transformer, and PDP in one at a time until the breaker trips,
This should isolate the problem component
M
C
ASSAGE
HAIR
PROBLEM NOISE DURING OPERATION
During Tapping and Kneading & Tapping
Sound of the air pump
Sound of rollers rubbing against the seat cover, or squeaky rubbing sound of the seat cover during
DreamWave mode
Clatter during DreamWave operation
Vibrating mechanism noise
Sound of the reclining seat back mechanism
Sound of the air massage cushions
These noises are a normal part of the product's operation and do not affect its performance in any
way.
REMOTE CONTROL BUTTONS DO NOT SEEM TO BE ACTIVATING NORMALLY
Check for the following possible problems:
5) Check if the power cord is fully plugged into the wall outlet.
6) Check if the power cord is fully plugged into the power connector located at the rear of the
chair.
7) Check if the main POWER switch at the rear of the chair is set to ON.
8) Check to be sure that the Child Safety Lock for disabling use of the chair is not locked.
THE MESSAGE "RESTART THE MAIN POWER SWITCH." APPEARS ON THE REMOTE
CONTROL DISPLAY
Set the main POWER switch located at the rear of the chair to OFF then back ON after about 5
seconds.
1. If the chair returns to normal, no further action is needed.
2. If the same message is displayed again, stop using the chair and unplug it from the wall outlet.
Contact the vendor for assistance.
THE AUTOMATIC SHIATSU POINT LOCATOR FUNCTION IS NOT WORKING PROPERLY
(The height of rollers does not fit the shoulders)
Sit further back in the chair so that your head rests firmly on the Shoulder Massage Unit. The roller
shoulder positions can be adjusted using the ROLLER buttons immediately after the Shiatsu points
are located.
(During air massage and vibration operations in Manual Selection mode, the Automatic Shiatsu
Point Locator Function is not available.)
MASSAGE ACTION STOPS IN THE MIDDLE OF THE PROGRAM
70080000 Manual Sogno DreamWave Spa
Rev A
Revision Date: 25 March 2010
Page 39 of 42

Advertisement

Table of Contents
loading

Table of Contents