Kyocera ECOSYS P6035cdn Operation Manual page 197

Troubleshooting > Troubleshooting
Symptom
Printouts are fuzzy.
Printouts are cut off.
Images are skewed.
Irregular horizontal lines
appear in the image.
The altitude is 1000 m or
higher and irregular
horizontal white lines appear
in the image.
The altitude is 1000 m or
higher and dots appear in
the image.
Checkpoints
Is the machine being used in conditions
of very humid, or humidity or
temperature rapidly changes?
―
―
Is the paper loaded correctly?
―
―
―
Corrective Actions
Use in an environment that has suitable
humidity.
Select the [Menu] key > [Adjust/Maint.]
> [Service Setting] > [Drum], and then
select [Yes].
ECOSYS P7040cdn: Select the [Menu]
key > [Adjust/Maint.] > [Service
Setting] > [Drum Heater], and then
select [On].
NOTE
This function cannot be turned on in
some regions.
Check the position of the paper width
guides.
ECOSYS P6035cdn: Select the [Menu]
key > [Adjust/Maint.] > [Service
Setting] > [MC] and increase the
adjustment value. Increase the
adjustment value 1 level at a time from
the current value. If there is no
improvement after the value is
increased by 1 level, increase by 1 level
again. If there is still no improvement,
return the setting to the original value.
Select the [Menu] key > [Adjust/Maint.]
> [Service Setting] > [Altitude Adj.],
and set to an elevation one level higher
than the current setting.
Select the [Menu] key > [Adjust/Maint.]
> [Service Setting] > [Altitude Adj.],
and set to an elevation one level higher
than the current setting.
10-10
Reference
Page
―
―
―
page 3-4
―
―
―