Safety Precautions; 1 General; 2 Transport And Storage - Palm GH Installation And Operation Manual

Water source geothermal heating & cooling heat pump
Table of Contents

Advertisement

.

1 Safety Precautions

It is required to read the Safety precautions in detail before
operation. The precautions listed below are all-important for
safety, please obey without fail.
.

1 1 General

Make sure that the fixed ground wire in the building is securely connected to earth.
Wiring tasks should be carried out by qualified electricians only, in addition, they should check the safety conditions
of power utilization, for example, check if the line capacity is adequate, and check if the power cable is damaged.
Users must not install, repair or relocate the unit.
Improper treatment might lead to the accidents e.g. personal injury caused by fire, electrical shock or unit's falling-
off, and water leakage in the machine. Please contact professional repair and service department of local dealer.
The unit shall not be installed at a spot with potential hazard of leakage of inflammable gas.
In case the leaked gas is congregated around the machine, there might be the risk of explosion.
Make sure that the foundation of installation is stable.
If the foundation is unstable, the outdoor unit may drop and cause a casualty accident. so this must be validated carefully.
Make sure that the electric leakage protection switch is fixed.
If no electric leakage protection switch is fitted at the beginning of the electric supply, it maybe cause electric shocks or
fires.
If any abnormity occurs in the unit (such as burned taste inside the unit), cut off the power supply immediately,
and contact professional repair and service department of local dealer.
Please observe the follow items when cleaning the unit..
Before cleaning, shut off the electric supply of the unit firstly to avoid injuries caused by fan in operation.
Do not rinse the unit by water because the rinsed unit may cause electric shock.
Make sure to shut off the electric supply before maintain the unit.
Please do not insert fingers or sticks into air outlet or air inlet.
.

1 2 Transport and storage

The machine must be transported and stored vertically.
The machine must be transported and stored vertically.
Note!
2

Advertisement

Table of Contents
loading

This manual is also suitable for:

Oh

Table of Contents