Install Your Management Module; Install An Uplink Module On The Management Module; Identify The Appropriate Slot For Installation; Align The Management Module With The Slot Module Guides - Net to Net Technologies 4-Module IP DSLAM IPD4000E Installation Instructions Manual

1.3 Install Your Management Module

A management module provides the functional control for Net to Net Technologies'
IPD4000E; the IPD4000E cannot function without one. There are several different
models available for purchase: refer to
information or contact your Net to Net sales representative to discuss your options.

1.3.1 Install an Uplink Module on the Management Module

An uplink module provides the upstream network connection for Net to Net
Technologies' IPD4000E; a management module cannot function without one.
Depending on the management module model that you plan to install in your
IPD4000E, you will need either a Media Interface Module (MIM) or an Uplink
Interface Module (UIM). Only one uplink module is required for operational
purposes, however two uplink modules may be installed, one in each port of the
management module, if redundancy is desired. Refer to your management
module and/or uplink module installation instructions at
http://www.nettonet.com/support/docs
C AUTION If a blank plate is removed from a management module uplink port, it must be replaced with an uplink
module. DO NOT OPERATE AN IPD4000E WITH A MANAGEMENT MODULE THAT HAS AN OPEN UPLINK
PORT.

1.3.2 Identify the Appropriate Slot for Installation

The IPD4000E is a five slot chassis: slots 1-4 are reserved for interface modules
and Slot U1 is reserved for a management module. The IPD4000E is factory
shipped with slots 1 and U1 open and ready for module installation.
Management Module Slot

1.3.3 Align the Management Module with the Slot Module Guides

With the management module printed circuit board (PCB) facing UP and the
management module model name, and Net to Net logo, on the RIGHT side of the
module faceplate (facing towards you), align the left and right edges of the PCB
with the U1 slot module guides on the IPD4000E.
IPD4000E Installation Instructions 220-0000097 rev01
http://www.nettonet.com/products
for further information.
for further
Page 5 of 17