Verify The Connection(S - Net to Net Technologies 4-Module IP DSLAM IPD4000E Installation Instructions Manual

Tuck the tab at the end of the strap down between the connector frames so that it
is out of the way of other connections.
Screw the right side of the RJ21 cable connector into the jack screw on the right
side of the RJ21 connector frame on the chassis.
N OTE If you are using a 120 or 180 degree cable, both the right and left sides of the cable connector should be
screwed to the RJ21 connector frame on the chassis.

1.7.5 Verify The Connection(s)

The LK (Link) LED for each port being connected with a remote modem will
illuminate solid or flashing green to indicate a connection has been established.
Link up time between interface modules and remote modems can vary from one
to five minutes depending on the quality, gauge and distance of the copper cable
pair(s) being used. Refer to individual interface module user guides at
IPD4000E Installation Instructions 220-0000097 rev01 Page 13 of 17