Table of Contents
Advertisement
ProSafe
Plus Switch Configuration Utility User Guide
®
2.
Click the list arrow in the DHCP Mode list box.
3.
Select Enable then click Apply.
The IP Address, Subnet Mask, and Gateway Address fields will be disabled (greyed out).
To disable DHCP address assignment, repeat the previous procedure and select Disable. When you click
Apply, you will able to manually enter IP Address, Subnet Mask, and Gateway Address information.
Manually Setting the IP Address Information
You can manually enter IP address and subnet mask values for the switch as well as the address of the
Gateway device to be used by the switch.
To define an IP interface information:
1.
Click System > Status > Switch Information. The Switch Information screen displays.
2.
Select Disable for the DHCP Mode. The IP Address, Subnet Mask, and Gateway Address fields will
be enabled.
3.
Enter the IP Address, Subnet Mask, and if available Gateway Address and click Apply.
Maintenance
The Maintenance feature allows you to change the password for the selected switch, perform a device
reboot, reset the switch to its factory default settings, or upgrade the switch firmware.
Change Password
To change the password for a switch:
1.
Select System > Maintenance. The Maintenance menu and Change Password feature will display.
2.
Enter the old password (default is "password") and the new password.
3.
Click Apply.
Device Reboot
Warning: Rebooting the switch will briefly disrupt network traffic through the switch.
To reboot the selected switch:
1.
Select System > Maintenance > Device Reboot. The Device Reboot dialog will display.
2.
Check the box in the Device Reboot dialog.
3.
Click Apply.
2-4
v1.0, February 2010
System Configuration
Hide quick links:
Advertisement
Table of Contents
