Reset All; Vcr Functions; Playback - Magnavox MDR161V Owner's Manual

Reset All

You can reset all settings to the defaults.
Note(s)
• The settings listed below will remain unchanged even after
resetting to the factory defaults.
- OSD language setting
- Clock setting
- Parental lock setting
imer programming information
- T
1
Press [SETUP], then use [K / L] to select "General
Setting", then press [OK].
• The "General Setting" menu will appear.
2
Use [K / L] to select "Reset All", then press [OK].
3
Use [K / L] to select "Yes", then press [OK].
Reset to factory default?
Yes
No
4
Use [K / L] to select "Yes" again, then press [OK].
Are you sure?
Yes
No
• The settings will now be reset.

VCR Functions

Caution when using S-video, component, or HDMI
connections for VCR:
• Only the audio/video playback is available with these
connections.
• Under the condition listed below, the playback image
cannot be viewed. Use the standard video connection in
such case:
- during DVD recording.
• HDMI video resolution cannot be changed when the unit
is in VCR mode.

Playback

1
Press [VCR], then insert a prerecorded tape.
• Refer to "How to Insert a Cassette Tape" (p.23).
2
Press [ B] to start playback.
3
Press [ C] to stop playback.
To pause playback: Press [ F].
Playback will pause and sound will be muted.
To resume playback: Press [ B].
Note(s)
• When a cassette tape without an erase-protection tab is
inserted, the unit will start playback automatically.
• Tracking will be automatically adjusted upon playback. To
adjust the tracking manually, press [TRACKING K / L] on the
remote control.
• S-VHS cassette tapes are not supported on this unit.
• Playback will stop when you change the output mode.
– 60 –
EN