4. Connecting Rod
D The connecting rods and caps are made of high
strength steel for weight reduction.
D Nutless-type plastic region tightening bolts are
used for a light design.
5. Crankshaft
D The diameter and width of the pins and journals have been reduced, and the pins for the No.1 and No.4
cylinders have been made highly rigid to realize a lightweight and low-friction performance.
D The crankshaft has 5 journals and 4 balance weights.
D A crankshaft position sensor rotor is pressed into the crankshaft to realize an integrated configuration.
Crankshaft Position
Sensor Rotor
No.1 Journal
ENGINE - 1NZ-FE ENGINE
Oil Hole
No.3 Journal
No.2 Journal
Plastic Region Tightening Bolts
Crank Pin
No.5 Journal
No.4 Journal
Balance Weight
EG-7
171EG07
171EG08