PNEUMATIC PLANISHING HAMMER
OWNER'S MANUAL
WARNING:
Read carefully and understand all ASSEMBLY AND OPERATION
INSTRUCTIONS before operating. Failure to follow the safety rules and
other basic safety precautions may result in serious personal injury.
Item# 49718
Thank you very much for choosing a Klutch product. For future reference, please complete the
owner's record below:
Serial Number/Lot Date Code: _______________
Save the receipt, warranty and these instructions. It is important that you read the entire manual
to become familiar with this product before you begin using it.
Thispneumatic planishing hammer is designed for certain applications only. Northern Tool and
Equipment cannot be responsible for issues arising from modification or use of this product in
an application for which it was not designed. We strongly recommend that this product not be
modified and/or used for any application other than that for which it was designed.
For technical questions please call 1-800-222-5381.
Table of Contents
Intended Use ----------------------------------------------------------------------------------------------- 1
Technical Specifications ---------------------------------------------------------------------------------- 1
Assembly --------------------------------------------------------------------------------------------------- 3
Before Each Use ------------------------------------------------------------------------------------------- 5
After Each Use --------------------------------------------------------------------------------------------- 6
Maintenance ----------------------------------------------------------------------------------------------- 6
Parts Diagram ---------------------------------------------------------------------------------------------- 7
Parts List --------------------------------------------------------------------------------------------------- 8
Troubleshooting ------------------------------------------------------------------------------------------- 8
Replacement Parts ---------------------------------------------------------------------------------------- 8
Limited Warranty ------------------------------------------------------------------------------------------- 9
Intended Use
The planishinghammer is used in metal fabrication and restoration to smooth large areas of metal,
welds and gentle panel crowning.
Technical Specifications
Property
Specification
Speed
875 - 1350 BPM
Operating Air Pressure
50 to 100 (maximum) PSI; 4 SCFM
Air Inlet
1/4", 18 NPT, female
Overall Dimensions
23"(L) x 5-1/2"(W) x 24"(H) (C-frame and Hammer)
Anvil-to-HammerOpening
4 inches (maximum)
Anvil Height
2-position anvil shaft mount with lock pin
Adjustment
3/8" to 1-1/4" opening (between head and anvil);4-position,
stepped anvil micro-adjustment block 1/16" height difference
between each level.
Anvil Sizes
1" Radius, 2" Radius and 3" Radius
Throat Depth
19-5/8"
Foot Pedal
7-1/4"(L) x 4"(W) x 3-1/2"(H) inches. Built-in air filter
PNEUMATIC PLANISHING HAMMER
OWNER'S MANUAL
Purchase Date: _______________
1 of 9