Toshiba MMY-MAP0806HT8(J)P Service Manual page 256

N . o P a t r o t b e e r p a l c e d
9 4-way valve
- detachment/
attachment
(continued)
MAP1406
MAP1606
Before starting the work, be sure to recover the
refrigerant of outdoor unit by removing it with a
refrigerant recovery device.
1. Detachment
W o k r p o r c e d
WARNING
Wear a pair of gloves.
Otherwise, you will risk an injury involving a
replacement part or some other object.
1) Remove the lower cabinet (front side).
2) Remove the inverter box in accordance with the
dismantling instructions.
3) Disconnect the 4-way valve coil and PMV1, PMV3
coils (2 pieces) and get all wiring located near the
4-way valve out of the way.
4) Remove brazed points (3 locations) for the PMV
assembly, which is placed in front of the 4-way
valve.
* Provide adequate cover for the PMV proper to
protect it from overheating.
5) Since it is difficult to simultaneously remove the
brazed points for the pipes located above the 4-
way valve (3 locations), cut through them just
below the brazed points using a saw, etc.
6) Detach the pipe located below the 4-way valve.
7) Remove the end sections of the pipes above the
4-way valve, which were cut in step 5).
8) Install a new 4-way valve.
* Provide adequate cover for the 4-way valve to
protect it from overheating. During the installation,
insert pipes firmly into the 4-way valve, or a
blockage or leakage involving brazing filler metal
may result.
9) Reinstall the PMV assembly, which was removed
in step 4).
* Provide adequate cover for the PMV to protect it
from overheating.
10) Reinstall all the coils removed in step 3), and put
the wiring back to its initial state.
11) Reinstall the inverter box in accordance with the
installation instructions.
12) Reinstall the lower cabinet.
u e r
For HT8(J)P, HT7(J)P, HT8(J)P-ME, HT7P-ME,
T8(J)P-E, HT8P-A model
For HT8(J)P-E, HT8(J)P-TR model
− 255 −
R e m a k r s
PMV1
PMV3
Brazed point
Brazed point
7) End sections of pipes (3 locations)
5) Cutting line
4-way valve
Brazed point