Troubleshooting - Craftsman 81338 Operator's Manual

Drawer cabinet

Hide thumbs

Table of Contents

Available languages

reiNstall DraWers

ball bearing slide - Pull slides and slide carrier out to fully

extended position (see illustration.) Hold the slide on the

cabinet while aligning it with the slide on drawer. Slightly

insert one side and repeat for the other side. Slowly push

drawer to its fully closed position to engage slide. Open

drawer and reclose to ensure proper operation.

slide carrier

slide

self closiNG sliDes

The self closing feature will pull the drawer closed when

the drawer is pushed past the slide detent. This is located

approximatley 1/2" from the fully closed position.

removiNG aND iNstalliNG sliDes

slide removal -

• The drawers in these units can be rearranged to fit your

specific needs. This means that drawers may be moved

or replaced as desired. For example, a 6-inch drawer

may be replaced by a 2-inch and a 4-inch drawer, or

three 2-inch drawers.

• First remove the drawer (Refer to Operation A).

• Lift and hold the spring retainer, and push the slide to-

ward the rear of the unit. The slide may now be removed.

slide installation -

• Place the slide in the appropriate position in the unit and

pull toward the front of the unit until the spring retainer

snaps into position and secures the slide.

• For smooth operation, make sure that the drawers are

matched with their original slides.