Makita 6705D Instruction Manual page 9

ASSEMBLY
Installing or removing the battery cartridge
*Always switch off the tool before insertion or removal of the battery cartridge.
*To remove the battery cartridge, ,pull out the set plate on the tool and grasp both sides of
the cartridge while withdrawing it from the tool.
*To insert the battery cartridge, align the
tongue on the battery cartridge with the
groove in the housing and slip it into
place. Snap the set plate back into place.
Be sure to close the set plate fully before
using the tool.
*Do not use force when inserting the bat-
tery cartridge. If the cartridge does not
slide in easily, it is not being inserted cor-
rectly.
Installing or removing the bit
CAUTION:
Always be sure that the tool is switched off and the batterv cartridqe is removed before
installing or removing the bit.
Use only the driver bit or socket bit shown
at right.
Do
not use any other driver bit or
socket bit.
To install the bit, pull the sleeve in the
direction of the arrow and insert the bit into
the sleeve as far as it will go. Then release
the sleeve to secure the bit.
11 mm
g 2 J
9
m m
Bit
I
I
Sleeve
To remove the bit, pull the sleeve in the direction of the arrow and pull the bit out firmly.
NOTE:
If the bit is not inserted deep enough into the sleeve, the sleeve will not return to its
original position and the bit will not be secured. In this case, try re-inserting the bit accord-
ing to the instructions above.
9