HCD-HP7
4-3.
How to Install the Gear (Mode C)
1 Align the mark on the rotary encoder (S771) with the projection of the assy.
2 Check that the cam (BU U/D) can not be rotated in the direction of arrow.
3 Install the gear (mode C)
rotary encoder
(S771)
mark
4-4.
How to Install the Gear (Mode Cam)
1 Slide the shaft in the direction of arrow.
2 Align mark A on the gear (mode cam) with mark B on the slider (mode cam) assy,
then install the gear (mode cam).
3 Check that mark C on the gear (mode cam) is in alignment with mark D on the cam (gear).
gear (mode cam)
cam (gear)
20
gear (mode C)
projection
– bottom view • front –
mark A
mark D
– bottom view • front –
cam (BU U/D)
chassis
shaft
slider (mode cam) assy
mark B
mark C