Pppoe (Dsl) - D-Link DIR-816L User Manual

Section 3 - Configuration
Choose PPPoE (Point to Point Protocol over Ethernet) if your ISP (Internet Service Provider) uses a PPPoE connection. Your ISP will provide you with a
username and password. This option is typically used for DSL services. Make sure to remove your PPPoE software from your computer. The software
is no longer needed and will not work through a router.
My Internet Select PPPoE.(Username/Password) from the drop-down menu.
Connection is:
Address Mode: In most cases, select Dynamic. IP. Select Static. IP if your ISP
assigned you the IP address, subnet mask, gateway, and DNS
server addresses.
IP Address: Enter the IP.Address (Static PPPoE only).
Enter your PPPoE Username.
Username:
Password: Enter your PPPoE Password and retype the password in the next
box.
Service Name: Enter the ISP Service.Name (optional).
Reconnect Mode: Select either Always-on, On-Demand, or Manual.
Maximum Idle
Enter a Maximum.Idle.Time during which the Internet connection
Time:
is maintained during inactivity. Enable Auto-reconnect to disable
this feature.
DNS Servers:
Enter the Primary and Secondary DNS Server Addresses of your
choice or enter DNS Server Addresses supplied by your ISP.
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the default
MTU.
MAC Address:
The default MAC Address is set to the Internet port's physical interface MAC address on the Broadband Router. It is not recommended
that you change the default MAC address unless required by your ISP. You can click on Clone.Your.PC's.MAC.Address to replace
the Internet port's MAC address with the MAC address of your Ethernet card.
D-Link DIR-816L User Manual
Internet Setup

PPPoE (DSL)

26