Troubleshooting - Polaroid xs100 User Manual

POLAROID XS100 USER GUIDE
system.
2. Select the Helmet Mount with a suitable length of strap.
3. Loosen and detach the ball joint nut from the Helmet Mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Helmet Mount Socket, and you should hear a loud
click, then tighten the Ball Joint Nut.
5. Adhere the double-sided adhesive mount to the base of the Helmet Mount and fitting piece.
6. Attach the Helmet Mount at one side of the helmet.
7 . Loop the strap to the other side of the helmet, through the vent of fitting piece, and back to the original side of the
helmet.
8. Fasten the strap with a Strap Clip.
9. Repeat on the opposite end of the strap until the Helmet Mount is firmly attached to the helmet.
10. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the Mount-Lock Ball Joint Nut is
tightened securely.
11. The ball joint system allows you to change the angle of the camera. Simply loosen the nut, adjust the camera angle
and re-tighten the nut.
Tips for Achieving a Secure Mounting
• When straps are not practical, the 3M® adhesive pads can be used to attach the mount to smooth surfaces like
a motorcycle helmet. And don't worry about the adhesive ruining the helmet; they're removed quite easily when
heat is applied (eg. a hairdryer).
• For best results, maximum adhesion of the adhesive pad is achieved by first cleaning the helmet surface
thoroughly where the pad will be attached. Apply the pad firmly and allow it to remain unused overnight. The dry
time allows the adhesive to create a stronger bond.
• For ultimate camera support, use the straps and the 3M® adhesive pads.
Mounting on a Handlebar or Pole (.75 to 1.4-inch diameter)
1. Loosen both bike mount screws.
2. Attach the bike mount to the handlebar or pole and tighten the screws until the mount is firmly secured.
3. Loosen and detach the ball joint nut from the bike mount.
4. Insert the Ball Joint through the Ball Joint Nut and then into the Bike Mount Socket, and you should hear a loud
click, then tighten the Ball Joint Nut.
5. Attach the Mount-Lock and camera into the Ball Joint Socket. Assure that the Mount-Lock Ball Joint Nut is
tightened securely.
18
6. The ball joint system allows you to change the angle of the camera. Simply loosen the nut, adjust the camera angle
and re-tighten the nut.

Troubleshooting

PROBLEMS CAUSES
1 LED flashes and Battery is
camera turns off exhausted
2 Cannot turn on the
camera
Red LED flashes Low battery
during recording
Cannot take photos or Memory is full
video (Green LED
flashes
Cannot take photos or 1 MicroSD card is
video Green and Red
LED flashes 2 Card is not formatted
Cannot find Connection Failure
removable disk after
connecting the
camera to the
computer
POLAROID XS100 USER GUIDE
SOLUTIONS
Recharge the battery
Recharge the battery
Replace memory
card with a new one
1 Insert MicroSD card
not inserted 2 Format the card
1 Make sure cable
connections are
secure and restart
the computer if
necessary.
2 Try a different USB
port on the computer
19