Cleaning And Maintenance - Jocel JFV-5007 Instruction Manual

Type of Fabric and Fabric Selector Dial
Caution：
Instructions on
Label

Cleaning and Maintenance:

Before cleaning, remove the plug from the socket and allow the iron to cool down sufficiently.
1. Wipe off the soleplate with a damp cloth and a non-abrasive (liquid) cleaner.
2. If the fiber is adhered to the soleplate, use a damp cloth with vinegar to wipe off the soleplate.
3. Never use strong acid or alkali in order to avoid damaging the soleplate.
4. If the scale blocks the steam hole, please remove the scale with toothpick; do not damage the
surface of soleplate.
5. Stand the iron on its end and let it cool down sufficiently, and meantime pour any remaining water
out of the box, set the dry/steam selector to position "O".
Simple Repair Methods
Problem
Not enough heat or Too
heat
No steam or Leakage
No burst of steam or no
vertical steam
Leaking water from
Soleplate
Little Steam
No Spraying
Please note that
may not ironed.
Type of Fabric
Nylon
Silk
Wool
Cotton
Linen
Possible Reasons
Rotate Thermostat Knob improperly or
unplugging
The Thermostat Knob has been set to
MIN
The(vertical) burst of steam function has
been used too often within a very
short period. The iron is not hot
enough
Set the thermostat knobl out of steam
range.
The heat is still not enough.
The water is over than max position
Check if the Steam Adjuster is in proper
location.
Steam hole is blocked.
Too little water in the water tank
No enough pressure or air inside
on the label means that this article
-11-
Thermostat Knob
MIN
MAX
Measurement
Correct Thermostat Knob in
position and check if the iron is
plugged.
Set the Thermostat Knob to the
required positioin.
Continue ironing in horizontal
position and wait a while
before using the (vertical)
burst of steam function again
Set the thermostat knob as per
steam range.
Open Steam Adjuster only after
the power light goes off.
Pour out the remaining water
Set the steam adjuster to the
proper location.
Clean hole with distilled water.
Fill water into the box
Press the spray nozzle by hand,
and push the spray button
several times continuously.