Table of Contents
Advertisement
Available languages
Available languages
Filling with Water:
Make sure iron is unplugged and the temperature dial is in the MIN position. Place iron on the heel rest, tilt
forward approximately 45 angle and pour water into the water-filling cover to the MAX position of the water
tank.
Vertical Steam
"Burst of Steam" can also be applied when holding the iron in vertical position; this is useful for removing
creases from hanging clothes, curtains, etc.
Dry Ironing：
3.
Set the Steam Adjuster to position O (No Steam)
4.
As per washing label of various clothes, set the correct ironing temperature to begin ironing.
Steam Ironing:
6. Fill in the water with water tank as per the water-filling methods.
7. Plug the appliance in the socket.
8. If only set Fabric Select Dial to MAX position as per the temperature indicator, steam iron will be
available, otherwise water may leak from the soleplate.
9. It indicates that the temperature has been ready until the power indicator light goes off.
10.
Set the Steam Adjuster correctly, increase steam output by pushing the Steam Adjuster rightward
and reduce the steam by pushing the steam adjuster leftward.
Anti Calc：
With a small filter built-in, which can make hard water soft, thus preventing any calc or flake accumulated on
the surface of soleplate, this features can prolong the life of the iron for long use.
Anti Drip：
With a bimetal assembled inside the iron, which can close the steam when the iron soleplate becomes very
low, so water leakage will never happen with this features.
Burst of Steam
This function works well for tough wrinkles and heavy fabrics. By pressing "Burst of Steam Button", an
intense burst of steam is emitted from the soleplate; this can be very useful when removing stubborn
creases. The shot of steam facility can be used only while ironing with high ironing temperature. For optimal
result, there should be 5 seconds rest between presses of the steam button. To prevent leaking water from
the soleplate does not press the steam button continuously for more than 5 seconds. Also allow at least one
minute interval before applying this burst of steam function.
Spraying Methods:
At any temperature by pressing the spray button a couple of times, the laundry can be damped down. Ensure
that there is enough water in the water tank.
Self-Cleaning
Use the self-cleaning function once every two weeks. If the water in your area is very hard, (i.e, when flakes
come out of the soleplate during ironing), the self-cleaning function should be used more frequently.). Make
sure the appliance is unplugged, move the steam adjuster rightward until it stop, then it functions.
-10-
Advertisement
Table of Contents
