Section 3: Diagrams; Circuit Boards Location; Printed Wiring Boards And Schematic Diagrams Information - Sony KDL-40XBR7 Service Manual

3-1. CIRCUIT BOARDS LOCATION

3-2. PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS INFORMATION

All capacitors are in μF unless otherwise noted. pF : μμF 50WV or
less are not indicated except for electrolytics and tantalums.
All electrolytics are in 50V unless otherwise specifi ed.
All resistors are in ohms. kΩ=1000Ω, MΩ=1000kΩ
Indication of resistance, which does not have one for rating
electrical power, is as follows:
1 1
/ W in resistance, / W and
4 10
: nonfl ammable resistor
: fusible resistor
: internal component
: panel designation and adjustment for repair
: earth ground
: earth-chassis
All variable and adjustable resistors have characteristic curve B,
unless otherwise noted.
Readings are taken with a color-bar signal input.
Readings are taken with a 10MΩ digital multimeter.
Voltages are DC with respect to ground unless otherwise noted.
Voltage variations may be noted due to normal production
tolerances.
KDL-40XBR7

SECTION 3: DIAGRAMS

AU
ILLUMINATION
MODULE
Pitch : 5mm
Rating electrical power :
1
/ W in chip resistance.
16
FBU
G6
D4
TOUCH SENSOR
H4
MODULE
All voltages are in V.
S : Measurement impossibility.
: B+line.
: B-line. (Actual measured value may be different).
: signal path. (RF)
Circled numbers are waveform references.
1 / W
4
The components identifi ed by shading and
only with part number specifi ed.
The symbol
side of the board. Replace only with fuse of the same rating as marked.
Les composants identifi es per un trame et une marque
securite. Ne les remplacer que par une piece portant le numero specifi e.
Le symbole
fusible de meme yaleur, comme maque.
NOTE: The components identifi ed by a red outline and a mark contain confi dential
information. Specifi c instructions must be adhered to whenever these components
are repaired and/or replaced.
See Appendix A: Encryption Key Components in the back of this manual.
H1VM
H3VM
! symbol are critical for safety. Replace
indicates a fast operating fuse and is displayed on the component
indique une fusible a action rapide. Doit etre remplace par une
KDL-40XBR7
! sont critiques pour la
22