Before You Start; Connect - D-Link GO-RT-N300 Quick Install Manual

Before you Start

• Users with DSL providers - If you are using a PPPoE connection, you will need
your PPPoE user name and password. If you do not have this information, contact
your Internet provider. Do not proceed until you have this information.
• Users with Cable providers - Make sure you unplug the power to your modem.
In some cases, you may need to turn it off for up to five minutes.
• Advanced Users - If your ISP provided you with a modem/router combo, you
will need to set it to "bridge" mode so the GO-RT-N300 router can work properly.
Please contact your ISP or refer to the user manual for your modem/router device.
Connect your Router
1
Unplug the power to your DSL or Cable modem.
2 Connect an Ethernet cable from the Internet port of the router to the
Ethernet port on your DSL or Cable modem.
4
Ethernet Port
Modem
Modem
Ethernet Cable
4 3 LAN 2 1 INTERNET
RESET
T
GO-RT-N300
POWER 12V 1A
WPS
Internet Port (yellow)