Configuring A Ce1/Pri Interface In E1 Mode; Configuring A Ce1/Pri Interface In Ce1 Mode - HP MSR Router Series Configuration Manual

Configuring a CE1/PRI interface in E1 mode

Step
1. Enter system view.
2. Enter CE1/PRI interface view.
3. Configure the interface to
operate in E1 mode.
4. (Optional.) Configure the
interface to perform alarm
indication signal (AIS) test.
5. (Optional.) Set other interface
parameters.
After you configure the CE1/PRI interface to operate in E1 mode, the system automatically creates a
serial interface numbered serial interface-number:0. This interface has the same logical features as a
standard synchronous serial interface and supports the following configurations:
Data link protocols, such as PPP and HDLC.
•
• IP addressing.
Interface backup settings if the interface is used as a primary or backup interface.
•
NAT and packet filtering if a firewall is to be set up.
•

Configuring a CE1/PRI interface in CE1 mode

Step
1. Enter system view.
2. Enter CE1/PRI interface view.
3. Configure the interface to
operate in CE1/PRI mode.
4. Bundle timeslots on the
interface into a channel set.
5. Set the framing format.
6. (Optional.) Enable RAI
detection on the interface.
(Optional.) Set other interface
7.
parameters.
A CE1/PRI interface in CE1/PRI mode can operate as a CE1 interface. You can bundle timeslots on a
CE1/PRI interface into up to 31 channel sets.
Command
system-view
controller e1 number
using e1
detect-ais
See "Configuring other CE1/PRI
interface parameters."
Command
system-view
controller e1 number
using ce1
channel-set set-number timeslot-list
list
frame-format { crc4 | no-crc4 }
alarm-detect rai
See "Configuring other CE1/PRI
interface parameters."
22
Remarks
N/A
N/A
By default, a CE1/PRI interface
operates in CE1/PRI mode.
Optional.
By default, AIS test is performed.
N/A
Remarks
N/A
N/A
The default operating mode is
CE1/PRI mode.
By default, no channel set is
created.
The timeslots on a CE1/PRI
interface can be bundled into
either channel sets or a PRI set, but
not the both at the same time.
The default is no-CRC4.
By default, RAI detection is
enabled on the interface.
N/A