Configuring Basic Settings Of An Ethernet Interface Or Subinterface - HP MSR Router Series Configuration Manual

Changing the active port of a combo interface
Step
1. Enter system view.
2. Enter Ethernet interface view.
3. Activate the copper combo
port or fiber combo port.
Configuring basic settings of an Ethernet interface or
subinterface
You can set an Ethernet interface to operate in one of the following duplex modes:
Full-duplex mode (full)—Interfaces can send and receive packets simultaneously.
•
Half-duplex mode (half)—Interfaces cannot send and receive packets simultaneously.
•
• Autonegotiation mode (auto)—Interfaces negotiate a duplex mode with their peers.
You can set the speed of an Ethernet interface or enable it to automatically negotiate a speed with its
peer.
Configuring an Ethernet interface
Step
1. Enter system view.
2. Enter Ethernet interface
view.
3. Set the interface
description.
4. Set the duplex mode of
the Ethernet interface.
5. Set the port speed.
6. Configure the expected
bandwidth of the
interface.
7. Restore the default
settings for the Ethernet
interface.
Command
system-view
interface interface-type
interface-number
combo enable { copper | fiber }
Command
system-view
interface interface-type
interface-number
description text
duplex { auto | full | half }
speed { 10 | 100 | 1000 |
10000 | auto }
bandwidth bandwidth-value
default
4
Remarks
N/A
N/A
By default, the copper combo port
is active.
Remarks
N/A
N/A
The default setting is in the format of
interface-name Interface. For example,
GigabitEthernet2/0/1 Interface.
The default setting is full for 10-GE
interfaces and auto for other Ethernet
interfaces.
Fiber ports do not support the half
keyword.
By default, the auto keyword is used.
Support for the keywords of the command
depends on the interface type. For more
information, see Interface Command
References.
By default, the expected bandwidth (in
kbps) is the interface baud rate divided by
1000.
N/A