Audiovox Rampage ACD-17 Owner's Manual page 11

The correct time-of-day can also be set into the
unit by pressing the Time/Frequency Selector
button. This procedure is outlined later in these
operating instructions.
cq cq cq cq cq
THEFT-DETERRENT LED
Located on the chassis behind the front panel, a
light-emitting diode (LED) will flash when the
panel is physically removed. The flashing light
serves as a visual warning to the would-be thief
that the unit has been disabled by removal of the
front panel.
cr cr cr cr cr
RESET BUTTON
A Reset button is located on the front panel of the
unit in the extreme lower right corner. The Reset
function is provided to protect the microproces-
sor circuitry and should only be activated under the
If a problem should develop while operating the CD player, an error code (ER-1, ER-2, ER-3, etc.)
may appear on the display panel. This can indicate a number of problems with the unit, includ-
ing a mechanical error or an error in the microprocessor control of the player. If an error code
should appear, try ejecting and reloading the disc into the player. While the disc is out of the unit,
make sure it is clean, undamaged, and loaded correctly (label surface up). You may also try
activating the RESET button
If the suggested measures do not solve the problem, contact an approved warranty station near
you for further assistance.
1. Turn the vehicle ignition and radio on.
2. Press and hold the Time/Frequency button
display will begin to flash.
3. Within 5 seconds of selecting the flashing display, press the VOL + button to adjust the
hours and the AM/PM indication to the desired setting.
4. Press the VOL - button to adjust the minutes to the desired time.
5. Five seconds after the last hour or minute adjustment is made, the time will be set in the
unit and normal operation will resume.
following circumstances as it will erase the
time memory:
1. Upon initial installation after all wiring is
2. If there is a malfunction of any of the
cs cs cs cs cs
This button ( ) is used to release the
mechanism that holds the front panel to the
chassis. To detach the front panel, press the
button so that the right side of the panel
releases outward. Grasp the panel at the right
side and disengage it from the left side of the
chassis. To re-attach the panel, engage the
left side onto the chassis; then gently press in
the right side until it clicks and locks into
place.
CD PL CD PLA A A A A YER ERR CD PL YER ERR YER ERR OR CODES OR CODES
CD PL CD PL YER ERR YER ERROR CODES OR CODES OR CODES
cr cr cr cr cr
on the unit, but this will also erase the time memory.
SET SET SETT T T T T ING THE CLOCK SET SET ING THE CLOCK ING THE CLOCK ING THE CLOCK ING THE CLOCK
cp cp cp cp cp
completed.
switches on the unit, pressing the RE-
SET button may clear the system and
return to normal operation.
PANEL RELEASE (REL) BUTTON
place.
for approximately 2 seconds; the time
11 11 11 11 11