Setting Data Port Output Rate; Other Commands - Symmetricom 5120A Operation And Maintenance Manual

For more information, see
Remote Session"
2. From the Command port Telnet session, enter:
help
A list of all the available commands displays.
To view help for a specific command:
1. Access the Command port.
For more information, see
Remote Session"
2. From the Command port Telnet session, enter:
help <command_name>
The usage of the command displays.
Commands validate their parameters and in most cases provide a list of valid parameters if
arguments are found to be invalid. This too can serve as a source of help using a command.

7.2.11 Setting Data Port Output Rate

The output rate of the data port can be set in samples per second using the set phaserate <rate>
command, where the output rate <rate> can be either 1,10,100, or 1000. The show phaserate
command can be used to determine what the current value of phase rate is.

7.2.12 Other Commands

The following lists some commands that were not documented in detail. Please use the help
network command as the authoritative source for all commands. See
Remote Commands"
reset
Reset the test set.
restorefactorydefaults
Restores all persistent settings to factory default values and reboots the test set. See
Restoring Factory Default Settings"
settings.
set <option> <args>
date options:
set date YYYYMMDDhhmmss
5120A/5115A Operations and Maintenance Manual
"7.1 Accessing the PNTS Remotely and Exiting the
on page 58.
"7.1 Accessing the PNTS Remotely and Exiting the
on page 58.
Note
This variation of the help command also lists various abbreviations for some
verbose commands. Issuing help measurelinear reveals that ml is a valid
shorthand for the command.
on page 64 for details.
on page 29 for more information about persistent
"7.2.10 Viewing Help for
"4.1.5
65