Setting Date And Time - Symmetricom 5120A Operation And Maintenance Manual

4.1.1 Setting Date and Time

All printouts produced by the test set show the test set date and time the print job was initiated. The
date and time is printed in the top left corner of the page. Date and time stamps on printouts can be
used to correlate printed data sets.
To set the system date and time:
1. Press Settings and Options.
2. Press Settings to access the Settings Screen (shown in
3. Press Date and Time.
4. Use the arrow softkeys to access the date/time fields you wish to modify.
5. Adjust the numeric fields as described in section
6. Select the preferred date/time format as described in section
Options"
The field labeled Sample shows how time stamps will be printed.
7. Press Apply to save the new date and time and/or time stamp format.
Note
The test set does not adjust for time changes due to daylight savings time.
22
on page 18.
Figure 8 on page 21).
"3.4.1 Numeric Parameters"
"3.4.2 Mutually Exclusive
4: Global System Settings
on page 16.