Haas+Sohn HRT 160 Operator's And Service Manual page 13

5. If adding an indexer to a Haas mill the settings must be set for the specific table. Refer to the
instructions in the mill manual or call the Haas service department.
6. Semi-Fourth Axis: Secure the servo control in servo pendant bracket (Haas part number SCPB)
as seen at the end of the introduction section.
7. Connect the large black cable from the table to the controller.
CAUTION: Never connect or disconnect this cable with the power on! Instant failure
8. Semi-Fourth Axis: Connect the AC line cord to a 120V AC grounded receptacle. The cord is a
three-wire ground type, and the ground must be connected. Power is 120VAC. The power service
must supply a minimum of 15 amps continuously. Conduit wire must be 12 gauge or larger and
fused for at least 20 amps. If an extension cord is to be used, use a three-wire ground type and the
ground line must be connected. Avoid outlets that have large electric motors connected to them.
Use only heavy duty 12 gauge extension cords capable of 20 amp load. Do not exceed a length of
30 feet.
9. Semi-Fourth Axis: Connect the remote interface lines. See "Interfacing to Other equipment"
section.
10. Connect the table to a standard shop air line (120 PSI Max). The line pressure to the brake is not
regulated. Do not exceed the maximum pressure.
NOTE: HAAS recommends the use of an in-line air filter/regulator for all tables. The
air filter will keep contaminates from entering the air solenoid valve.
11. Check the oil level. If it is low, add oil. Use MOBIL SHC-630 synthetic gear oil (Viscosity Grade
ISO 220). For the HRT210SHS use Mobil SHC-626 synthetic gear oil (Viscosity Grade ISO 68).
12. Save the packing materials in case you need to ship the unit.
13. At the end of the workday or shift, it is important to clean the rotary table. The table should be free
of any chips or grime. Clean with a chip brush and apply a coat of a rust preventative.
CAUTION! Do not use air gun around front or rear seals. Chips may damage seal if
14. Turn on the mill (and servo control, if applicable) and home the table by pressing the Zero Return
button. All Haas indexers home in the clockwise direction as viewed from the platter. If the table
homes counter-clockwise, press E-stop and call the Haas service department.
12
will result!
blown in with an airgun.
96-5047 rev L June 2005