Optional Servo Control Bracket; Haas Tailstocks - Haas+Sohn HRT 160 Operator's And Service Manual

1.7 O S C B
PTIONAL ERVO ONTROL RACKET
Designed to work specifically with the Haas line of CNC mills. This bracket keeps the Servo Control in easy
reach of the operator, allowing for easy programming between the Haas mill and Rotary table. Contact your
Haas dealer to order. (Haas part number: SCPB)
Installed Servo Control Bracket
1.8 H T
AAS AILSTOCKS
Tailstocks must be properly aligned to the rotary table before using.
Clean bottom surface of tailstock casting before mounting to mill table. If there are any noticeable burrs or
nicks on the mounting surface, clean them with a deburring stone.
See the Haas tailstock manual (96-5000) for pneumatic tailstock's operating pressure.
Tailstocks cannot be used with the HRT320FB table.
96-5047 rev L June 2005 9