Display Board; Loudspeaker (6.5 Cm) (Sp4) (R-Ch) - Sony HT-ST7 Service Manual

2-24. DISPLAY BOARD

1 saranet cushion
5 flexible flat cable (15P) (FFC6)
(CN801)
Note: When installing the flexible flat cable,
ensure the colored line.
No slanting after insertion.
colored line
connector

2-25. LOUDSPEAKER (6.5 cm) (SP4) (R-ch)

1 two screws
(3.5)
4 loudspeaker (6.5 cm)
(SP4)
3 terminal (wide side)
[blue]
2 Remove the loudspeaker
(6.5 cm) (SP4) in the
direction of an arrow.
2 screw (BVTP3
12)
3 collar (damper)
8 bushing (damper)
2 screw
(BVTP3 12)
3 collar (damper)
8 bushing (damper)
3 collar
(damper)
8 bushing (damper)
flexible flat cable
– Front bottom view –
1 two screws
(3.5)
3 terminal (narrow side)
[black]
– –
7 holder (LED) assy
6 two claws
9 DISPLAY board
2 screw
(BVTP3 12)
4 Remove the DISPLAY board block
in the direction of an arrow.
Note 1: When installing the loudspeaker (6.5 cm) (SP4),
make the position of terminals as shown
in the figure below.
terminals position
(narrow side) [black]
terminals position
(wide side) [blue]
Note 2: When installing the speaker wire, make the
position of caulking of terminals is outside.
wide side
[blue]
loudspeaker (6.5 cm) (SP4)
HT-ST7
2 screw
(BVTP3 12)
3 collar (damper)
8 bushing (damper)
loudspeaker (6.5 cm)
(SP4)
narrow side
[black]
23