Setting Up The Base And Charging Cradle (If Included); Connecting The Base - Gigaset C610A Manual

First steps

Setting up the base and charging cradle (if included)

The base and charging cradle are designed for use in enclosed dry rooms with a
temperature range of +41°F to +113°F.
¤
Install the base on a level, non-slip surface in a central location in your house or
flat or mount the base or charging cradle on the wall (
Please note
Pay attention to the range of the base.
This is up to 984 feet in unobstructed outdoor areas and up to 165 feet inside
buildings. The range is reduced when Eco Mode (
The phone's feet do not usually leave any marks on surfaces. However, due to the
multitude of different varnishes and polishes used on today's furnishings, the
occurrence of marks on the surfaces cannot be completely ruled out.
Please note:
u
Never expose the telephone to the influence of heat sources, direct sunlight or
other electrical devices.
u
Protect your telephone from moisture, dust, corrosive liquids and fumes.

Connecting the base

¤
First connect the tel-
ephone jack
insert the cables into
the cable ducts.
¤
Then connect the
power adapter 1.
Please note:
u
The power adapter
must always be connected, as the phone will not operate without electrical
power.
u
Only use the power adapter and phone cord supplied. Pin connections on
telephone cables can vary (
10
and
2
2
1
¢
page 60).
¢
page 70).
¢
page 45) is activated.
1
1