Table of Contents
Advertisement
PREPARATION
This unit supports both the NTSC and PAL signal system.
Before inputting analogue signals (composite or YC separate video signals), please select the
signal system.
POWER
button
POWER
A.DUB
AG-DV2500
MIC
REMOTE
INPUT
OFF
LINE
9PIN
WIRELESS
DV
S-VIDEO
Steps
1.
Set the unit to the POWER OFF mode.
2.
Please select the signal system with the NTSC/PAL switch on the rear panel.
3.
Press the POWER button to engage the POWER ON mode. Either the NTSC or PAL
indicator on the front will then light up, according to the NTSC/PAL switch setting.
Memo
• In the playback mode, the signal system of the tape is automatically identified, regardless of the
NTSC/PAL switch setting.
• During DV signal input, the signal system of the input signal is automatically identified, regardless
of the NTSC/PAL switch setting.
• This unit is equipped with a function to automatically detect the signal system of the cassette being
played back or the signal being received at the DV input connector. However, this function may not
operate correctly in some instances.
To ensure the correct system selection, it is recommended that you match the rear panel's NTSC/
PAL switch to the signal system of the input signal or playback tape.
• When the unit enters the STOP mode, the NTSC/PAL switch setting will be engaged.
• If a tape recorded in both NTSC & PAL signal systems is played, the video, audio or time code may
be distorted at the position where the signal system is switched.
• When the signal system of the tape and the NTSC/PAL setting differ, video and sound output will be
upset for about 5 seconds after playback starts or stops.
• NTSC/PAL signal system conversion is not possible.
E-28
– Selecting the NTSC/PAL signal system –
NTSC
PAL
indicator
indicator
DVCAM
NTSC
PAL
REC INH.
1 / 3
CH
2 / 4
AUDIO
OCK HAZARD - DO NOT OPEN.
CHOC ELECTRIQUE - NE PAS OUVRIR.
REC
PLAY
REW
STOP
/4
LINE
NTSC/PAL switch
VIDEO
I
N
9PIN REMOTE
O
AUX
U
T
S -VIDEO
DC
12V
NTSC
PAL
Advertisement
Table of Contents
