Reset All Vcr Memory Functions; Location Of Controls - Panasonic PV-V464S Operating Instructions Manual

Location of Controls/ Reset All VCR Memory Functions
Multi Function Display (FRONT DISPLAY)
Power Indicator
Lights up when power is on.
Clock/ Status/ Channel/ Speed Display
Displays current time. Briefly displays VCR
status when you press a function button,
channel number or "L1" or "L2" when you
select channel or line input, and recording
speed when you press SPEED.
Rear View of the VCR
AC Power Plug
While plugged into an AC outlet, the
VCR consumes 0.95 W of electrical
power in off condition.
Video Input Connector

Reset All VCR Memory Functions

Returns to factory setting. Use if relocating VCR, or if Initial Setup needs to be redone.
• Make sure a tape is not inserted in the VCR.
1
Note to CABLE system installer
This reminder is provided to call the CABLE system installer's attention to Article 820-40 of the NEC in USA
(and to the Canadian Electrical Code in Canada) that provides guidelines for proper grounding and, in
particular, specifies that the cable ground shall be connected to the grounding system of the building, as
close to the point of cable entry as practical.
Panasonic Consumer Electronics Company,
Division of Matsushita Electric Corporation of America
One Panasonic Way Secaucus, New Jersey 07094
Panasonic Sales Company ("PSC"),
Division of Matsushita Electric of Puerto Rico, Inc.
Ave. 65 de Infantería. Km. 9.5 San Gabriel Industrial Park, Carolina,
Puerto Rico 00985
Audio Input Connector
(L/R)
Video Output
Connector
2
Timer Indicator
Lights up when the VCR is set for a Timer
Recording, or when One Touch Recording
(OTR) is used.
Flashes when a Timer Recording is set, but a
tape has not been inserted into the VCR.
Hi-Fi Indicator
Lights up when Hi-Fi audio is present
in Playback Mode.
AUDIO
IN FROM ANT.
R
L VHF/UHF
VIDEO OUT TO TV
IN 1 OUT
Audio Output
Connector (L/R)
1
Turn VCR Power on.
2 Press and hold both PLAY and CHANNEL
on the VCR for more than 5 seconds.
• The power shuts off.
3 Perform "Initial Setup (Ready to Play)" on
page 4.
- 8 -
VCR Indicator
Lights up when the VCR/TV
selector is set to VCR.
VHF/UHF Antenna
Input Terminal
VHF/UHF Antenna
Output Terminal
Printed in Indonesia
LSQT0813 A
P
S1203-1014