Copying Your Tapes (Dubbing) - Panasonic PV-V4624S Operating Instructions Manual

Copying Your Tapes (Dubbing)

Connection
(Rear connection shown.)
VCR
(HiFi)
AUDIO OUT
Connect VIDEO OUT jack on Playing VCR to VIDEO IN jack on Recording VCR.
1
To monitor the dubbing, also connect a TV as shown.
2
Connect AUDIO L/R OUT jacks on Playing VCR to AUDIO L/R IN jacks on Recording VCR.
In place of a Playing VCR, you can use other equipment, such as a Camcorder.
Simply connect the unit's Audio/Video outputs to the Recording VCR.
Playing (Source) VCR
1
Insert pre-recorded tape.
2
3 Press PLAY, then PAUSE/SLOW
immediately to enter PLAY/PAUSE mode.
4
Press PLAY to start dubbing.
Playing VCR starts playback.
5
Press STOP to stop dubbing.
To Monitor Dubbing on Your TV
1
Turn your TV on and tune to the Recording
VCR channel (CH3 or CH4).
2
Set the VCR/ TV Selector on the Recording
VCR to "VCR."
• Dubbing tapes protected with Copy
Note
Guard will have poor quality results.
Caution :
Unauthorized exchanging and/or copying of copyrighted recordings may be
copyright infringement.
*Important: If a remote control button does not work when pressed,
IN FROM ANT.
R
R
L
AUDIO IN
VIDEO OUT
The operation of steps 4 and 5 must be done on both playing
and recording VCRs at the same time.
press the VCR button on the remote and try the button again.
VCR
(HiFi)
OUT TO TV
R
L
VIDEO IN
Front of VCR
Recording (Editing) VCR
Insert blank tape with record tab.
Press INPUT* to set VCR Input mode to LINE1
for Video Input (Rear) or to LINE2 for Video Input
(Front). (See "Selecting the Input Mode" below.)
Press REC, then PAUSE/SLOW immediately to
enter REC/PAUSE mode.
Press PAUSE/SLOW to start dubbing.
Recording VCR starts recording.
Press STOP to stop dubbing.
Selecting the Input Mode
Method 1:
Press INPUT repeatedly.
Channel Number ↔ ↔ ↔ ↔ ↔ LINE1 ↔ ↔ ↔ ↔ ↔ LINE2
Method 2:
Press CH
Display will change as below.
LINE2
• "L1" or "L2" lights on Multi-Function Display
(about 4 sec.) when LINE1 or LINE2 is
selected.
• LINE1: For rear audio/video connection.
LINE2: For front audio/video connection.
- 9 -
TV
R
L
VHF/UHF
VIDEO IN 2 L-AUDIO IN2-R
(Front Audio L/R Video IN jacks
are also provided)
/ .
1
2 3
(CABLE)
(TV)
LINE1 125 or 69