Troubleshooting - Fakir Vita Instruction Manual

electrical shock or malfunction
-
If the front cover of the plasma dust collector
is not properly installed, no electricity will
be connected
-
Please make sure the plastic wrap for the
electrical discharge wire is located at its
proper position.
Cleaning and Replacing filters
-
The filter will collect large amount of the
dust , you may use a soft brush to clean it.
Please replace with new filters if using for
more than one year or the filter is heavily
polluted.
Replacing UV Lamp
-
Each 12 months, you may need to change

Troubleshooting

Problem
Why is it so hard for the filter to get rid of
dust and odor?
Why is it so difficult to collect dust and
eliminate odor?
Cannot turn on the unit
NOTE: The unit will not operate if the plasma dust collector or the front cover
is not properly installed.
10
UV lamp.Turn off the unit, unplug the plug
from the socket and make sure the item is
off power.Gently take out the UV lamp form
the UV lamp holder.
-
Put new UV lamp into the UV lamp holder
and make sure it is in its proper position.
Reinstating
-
After cleaning and drying every part, then
install the unit. Put every part back together
with the same steps but with opposite
sequence.
-
There's metal electrode at the bottom of
the plasma dust collect, please make sure
to install at its proper position. Otherwise,
the device cannot be energized.
-
There's safeguard protective switch
designed for this device, please make sure
to install front cover properly. Otherwise,
the device cannot be energized.
Possible Cause
The filter has been saturated with a
serious amount of dust.
The electrical discharge wires or the
plasma dust collector already gets too dirty.
Has any electrical discharge wire been
disconnected or broken?
Has the plug been loosened or
disconnected with the socked?
Has the unit been properly reassembled
after being cleaned?
Soulution
Please replace with new filter.
Please clean and maintain this collector.
Please contact Authorized Fakir Service for
additional purchase.
Please check the plug.
The unit will not operate if the plasma dust collector
or the front cover is not properly installed.