Fakir Vita Instruction Manual page 9

Timer
-
Press TIMER button to set operation timing.
-
Under the operation function, the operation
timing will be set according to the number
of times you press the TIMER button. The
LED will show the following sequence of
timing.
ION – UV
-
Press the ION.UV button, you may control
the ON or OFF of the ions function and UV
lights and the LED indicator light will show
the working status.
C l e a n i n g a n d
- During cleaning and maintenance, please
turn off and unplug the device.
- Cleaning and maintenance every 2 to 3
months are recommended.
Dissembling the device
-
Take down the front cover: Put your hand
to the flute part on top of the front cover,
pull out the front cover and take down the
front cover.
-
Take out the plasma dust collector and pre-
filter.
-
Take out the HEPA high-performance filter:
hold the handle on two sides of the filter
and gently pull it out.
Clean the front cover
-
The front cover can be cleaned with clean
flowing water. If heavily polluted, you may
put the cover into the liquid with mild
detergent and wash thoroughly with clean
water.
Clean the Pre-filter
-
Take down the pre-filter from the plasma
dust collector and wash with clean flowing
water. If heavily polluted, you may put the
cover into the liquid with mild detergent
M a i n t e n a n c e
and wash thoroughly with clean water.
Clean the Plasma Dust Collector
-
Use mild detergent to clean
-
Use a scouring pad or toothbrush to clean
the dust collector
-
Achieve better result with warm water
(below 40C)
-
If it is hard to eliminate all dirt, presoak with
diluted detergent and then use a toothbrush
to scrub.
-
Please beware not to damage any wiring
when cleaning the dust collector. In case
if any electrical discharge wire is broken,
the device will lose part of or all of its dust
collecting function
-
Any broken wire should be thrown away
instead of being left inside the unit.
Otherwise, short-circuit or high-voltage
spark would be resulted. Also, the circuit
control of the device would be affected.
-
Please contact the distributor for additional
electrical discharge wire
-
Please do not clean using acidic or alkaline
detergent that can create rust on the surface
of device
Thorough clean and dry
-
After cleaning, please completely dry the
unit before use. Otherwise, it could cause
9