ELNA eXplore 240 Service Manual page 4

PROBLEM
3. BREAKING 1. INITIAL SEWING SPEED IS
UPPER TOO FAST.
THREAD
2. THREAD PATH IS
INCORRECT.
3. NEEDLE IS BENT OR DULL.
4. UPPER THREAD TENSION IS ADJUST UPPER THREAD
TOO STRONG.
5. NEEDLE SIZE IS
INAPPROPRIATE FOR
FABRIC.
6. NEEDLE EYE IS WORN.
7. NEEDLE HOLE IN NEEDLE
PLATE IS WORN OR BURRED. REPLACE THE NEEDLE PLATE.
4. BREAKING 1. INCORRECTLY THREADED
BOBBIN BOBBIN CASE.
THREAD
2. TOO MUCH THREAD IS
WOUND ON THE BOBBIN.
3. LINT IS STUCK INSIDE THE
HOOK RACE.
4. THREAD QUALITY IS
TOO LOW.
5. THREAD IS JAMMING
AROUND THE BOBBIN.
6. BOBBIN THREAD TENSION IS
TOO STRONG.
5. NEEDLE 1. NEEDLE IS HITTING THE
BREAKS NEEDLE PLATE.
2. NEEDLE IS BENT OR WORN.
3. NEEDLE IS HITTING THE
HOOK RACE.
4. THE FABRIC MOVES WHILE SEE MECHANICAL
THE NEEDLE IS PIERCING
IT, OR THE NEEDLE ZIGZAGS
WHILE IN FABRIC.
5. FABRIC IS BEING PULLED TOO GUIDE THE FABRIC GENTLY
STRONGLY WHILE SEWING. WHILE SEWING.
CAUSE
2
REMEDY
START WITH MEDIUM SPEED.
USE THE PROPER THREAD
PATH.
REPLACE WITH A NEW NEEDLE.
TENSION CORRECTLY.
USE APPROPRIATE NEEDLE
AND THREAD FOR FABRIC
IN USE.
CHANGE THE NEEDLE.
REPAIR THE HOLE OR
THREAD BOBBIN CASE
CORRECTLY.
ADJUST THE POSITION OF
STOPPER.
CLEAN THE HOOK RACE.
CHANGE TO A HIGH QUALITY
SEWING THREAD.
CLEAR OUT THE JAMMING
THREAD.
ADJUST BOBBIN THREAD
TENSION CORRECTLY.
SEE MECHANICAL
ADJUSTMENT "NEEDLE DROP."
CHANGE THE NEEDLE.
SEE MECHANICAL
ADJUSTMENT "CLEARANCE
BETWEEN NEEDLE AND HOOK."
ADJUSTMENT "NEEDLE SWING."
MODEL:eXplore 240
REFERENCE
P. 8
P. 9
P. 12
P. 13, 14
P. 11