Advertisement
5. Installation Guidelines
1. Fix the yoke bracket to the surface using a suitable fixing method. (Fig.1)
2. Feed the speaker cable through the cable clamp cover then connect the
Euro-type plug to the wires, observing the correct polarity. (Fig.2)
3. For connection to the loudspeaker, use Pins 1 (+) and 2 (-).
Pins 3 (-) and 4 (+) are in parallel for connection to additional speakers
in a distributed line. (Fig.3)
4. Offer the speaker up to the bracket and attach using the thumb
screws provided (Fig.4)
5. Connect the Euro-type plug then replace the rubber grommet to
ensure the speaker is sealed. (Fig.5)
6. The DVS 4t models are fitted with 30 W transformers. (Fig.6)
THE SPEAKER IS SUPPLIED IN LOW IMPEDANCE MODE.
NEVER CONNECT THE SPEAKER TO A 70/100 VOLT AMPLIFIER WHILE
IT IS SET FOR LOW IMPEDANCE.
7. The DVS 6t and DVS 8t models are fitted with 60 W transformers. (Fig.7)
THE SPEAKER IS SUPPLIED IN LOW IMPEDANCE MODE.
NEVER CONNECT THE SPEAKER TO A 70/100 VOLT AMPLIFIER WHILE
IT IS SET FOR LOW IMPEDANCE.
5. Installation Guidelines
DVS Series Operation Manual rev 2.0.0
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
Fig.6
Fig.7
7
Advertisement
