Memory Input Operations - Agilent Technologies 34950A User Manual

64-bit digital i/o and counter module
Table of Contents

Advertisement

Memory Input Operations

For memory input operations, the interrupt line is an output and is set on
a pattern match or when the memory has been filled. You can set the
interrupt line to be driven or open collector using the
SENSe:DIGital:HANDshake:DRIVe
N O T E
When set to
The high output voltage is set for both the handshaking and interrupt line
on a bank with the
When set to
to high impedance mode when in the 'High' state. The open collector mode
requires external pull- ups.
The
cause the interrupt to be asserted. When set to
given when the memory is full. When set to
asserted when the pattern is detected (see page
condition is removed, the interrupt is de- asserted.
The interrupt line is enabled by the
command and the status can be checked using the SCPI Status System
(refer to the Programmer's Reference Help file).
Agilent 34950A 64-Bit Digital I/O and Counter Module User's Guide
The settings for drive mode, output drive level, and input threshold also
apply to the bank's handshake lines.
the interrupt line will be driven by the module.
ACTive
SOURce:DIGital:HANDshake:LEVel
OCOLlector
SENSe:DIGital:INTerrupt:MODE
command.
the interrupt line will be driven low, but will go
command sets the condition that will
COMPare
SENSe:DIGital:INTerrupt:ENABle
Interrupt Lines
command.
the interrupt is
MFULl
the interrupt is
page
21). When either
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents