Panasonic AJ-D750P Operating Instructions Manual page 57

USER menu
<AUDIO>
No.
716
717
718
719 PB FADE
720
The underline on the setting item denotes the initial setting.
(continued)
Item Setting
Superimposed
No. Superimposed
display
display
REC CUE 0000
0001
0002
CH1+2
0003
SCALE 0000
DISP 0001
DV
0000
OUTPUT 0001
0002
0000
0001
0002
EMBEDDED
0000
AUD 0001
- 5 7 -
CUE
This selects the input signal recorded in CUE.
CH1
0: CUE IN
CH2 1: Audio CH1 input
2: Audio CH2 input
3: Audio CH1 and CH2 MIX signal
FULL
This selects the level meter scale.
FINE
0: Full scale.
1: Fine scale.
ST1
This selects the AUDIO CH1 and CH2 output signals during
ST2 DV format playback.
ST1+2 0: The CH1 track signals are output to CH1 and the CH2
track signals to CH2.
1: The CH3 track signals are output to CH1 and the CH4
track signals to CH2.
2: The mixed CH1 and CH3 track signals are output to CH1
and the mixed CH2 and CH4 track signals to CH2.
<Note>
This item setting is valid only when the tape recorded on the
four channels of the DV format is played back.
AUTO This selects the processing method for the audio edit points
(IN point, OUT point) during playback.
CUT
0: According to the status during recording.
FADE
1: Forced CUT
2: Forced FADE
This selects whether to superimpose the audio data onto the
OFF
serial output.
ON
0: Data is not superimposed.
1: Data is superimposed.
<Note>
This item is valid when the optional serial interface board has
been installed.
Description