Assembly And Set-Up - Razor PowerWing DLX Owner's Manual

ASSEMBLY AND SET -UP
Attaching the Platforms
Tools Required: Two (2) 5 mm Allen wrenches
1
Using two (2) 5 mm Allen
wrenches, remove the two coupling
bolts from the frame.
Attaching the Handlebars
Tools Required: 5 mm Allen wrench
1
Remove the plastic protector
covering the wedge.
Note: Slide the handlebar stem
down into the front fork until it
fi ts snuggly into the lock nut on
the headset.
2
Align the holes on the right
and left platforms with the holes
on the frame.
2
Loosen the black folding knob,
and swing to the 6 o'clock position
to unfold the handlebar stem.
Note: Make sure the front
wheel is pointed straight ahead,
the handlebars square to the
front wheel and the Razor logo
facing the front.
3
Re-insert the coupling bolts
and tighten using two (2) 5 mm
Allen wrenches.
3
Insert the handlebar stem
into the front fork. You may need
to slightly loosen the wedge
using a 5 mm Allen wrench to
allow it to slip into the front fork.
Note: The cable and wire
assembly from the handlebar must
not wrap around the handlebar
stem or handlebar. Sharp bends
or twisting of the brake cable can
cause the brake to malfunction.
3
WARNING:
Parents must assist children in
the procedures to unfold and fold
PowerWing DLX.
WARNING:
Keep your fi ngers clear of the
pivoting mechanism when folding or
unfolding the PowerWing DLX, and
make sure others are standing clear.