Table of Contents
Advertisement
Quick Links
ELECTRIC HUB MOTOR SCOOTER
NOTE: The unit must be traveling at least 5 km/h (3 mph) before motor will engage.
Kick to start to at least 5 km/h (3 mph) while applying the throttle to engage motor.
OWNER'S MANUAL
Read and understand this entire manual before allowing
child to use this product! For assistance contact Razor.
DO NOT RETURN TO STORE.
NOTE: Manual illustrations are for demonstration purposes only.
Illustrations may not reflect exact appearance of actual product.
Specifications subject to change without notice.
Please have your product along with the 19 character product I.D. code with you
before contacting Razor for warranty assistance and/or replacement parts.
Product I.D. Code: _____________ - ____________ - ____________
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Razor PowerCore Siege
Summary of Contents for Razor PowerCore Siege
- Page 1 Kick to start to at least 5 km/h (3 mph) while applying the throttle to engage motor. OWNER’S MANUAL Read and understand this entire manual before allowing child to use this product! For assistance contact Razor. DO NOT RETURN TO STORE. NOTE: Manual illustrations are for demonstration purposes only.
-
Page 3: Table Of Contents
Need Help? Visit our website for replacement parts, product support, a list of authorized service centers in the US and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer... -
Page 4: Safety Warnings
ATTENTION TO SAFE OPERATION. USE CAUTION. Need Help? Visit our website for replacement parts, product support, and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is listed at the... -
Page 5: Before You Begin
Estimated Assembly and Set-Up Time basis of its compatibility with the frame, fork and all other parts. Razor recommends assembly by an adult. Certain aftermarket products Allow up to 10 minutes for assembly, not including initial charge time. may not be compatible and will Allow up to 12 hours for charge (see page 5 for charging information). -
Page 6: Assembly And Set-Up
ASSEMBLY AND SET-UP Attaching the Handlebars Required Tool: 5 mm Allen Wrench (included) WARNING: Do not attempt to thread the stem into the front fork thread. Note: Make sure any cables/wires are out of the way before inserting the stem into the fork. WARNING: Failure to properly tighten the collar clamp may allow the handlebars to... -
Page 7: Charging The Battery
Need Help? Visit our website for replacement parts, product support, and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is listed at the... -
Page 8: Pre-Ride Checklist
PRE-RIDE CHECKLIST Brakes Safety Gear Check the brake options for proper function. When you Always wear proper protective gear, such as an approved squeeze the brake lever (on handlebar) or step on the safety helmet. Elbow pads and kneepads are recommended. rear-fender brake, the brake should provide positive braking Always wear athletic shoes (lace-up shoes with rubber action. -
Page 9: How To Stop
Need Help? Visit our website for replacement parts, product support, and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is listed at the... - Page 10 Disconnect motor cables. Need Help? Visit our website for replacement parts, product support, and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is listed at the...
- Page 11 REPAIR AND MAINTENANCE Note: When re-inserting the motor wires into the connector, make sure the red wire connects to the blue wire and the black wire connects to the brown wire. Note: Motor Control Module Black Blue Black Brown Remove motor cable wires from connector using Remove two (2) motor housing screws using the an awl.
- Page 12 Disposal: Your Razor product uses sealed lead-acid battery which must be recycled or disposed of in an least 15 minutes and contact environmentally safe manner. Do not dispose of a lead-acid battery in a fire. The battery may explode or leak.
-
Page 13: Troubleshooting Guide
+1 800 954 354 (AU) / +0 800 003 221 (NZ) to speak to a live Customer Service Representative. Need Help? Visit our website for replacement parts, product support, and customer service contact information at www.razor.com. Please have the product I.D. code (located on the white label of your product) available for better assistance. Additional Customer Service contact information is listed at the... -
Page 14: Electric Scooter Parts
ELECTRIC SCOOTER PARTS Keep your scooter running for years with genuine Razor parts. Visit our website or e-mail us for more information on spare part availability. (Specifications subject to change without notice.) Handlebar Grips (Right/Left) 10. Rear Fender Brake Handlebar Stem 11. - Page 15 NOTICE: INSURANCE YOUR INSURANCE POLICIES MAY NOT PROVIDE COVERAGE FOR ACCIDENTS INVOLVING THE USE OF THIS SCOOTER/ELECTRIC RIDE-ON PRODUCT. TO DETERMINE IF COVERAGE IS PROVIDED, YOU SHOULD CONTACT YOUR INSURANCE COMPANY OR AGENT.
-
Page 16: Customer Service Contact Information
Printed in China for Razor USA LLC. Copyright © 2003-2023 Razor USA, LLC. All rights reserved. Razor® and the Razor logo design are among the registered trademarks of Razor USA LLC in the United States and/or select foreign countries. Power Core and the ™...
Need help?
Do you have a question about the PowerCore Siege and is the answer not in the manual?
Questions and answers