Button Functionality Hm2236; Button Combinations Hm 2236 - HM-Funktechnik HM 2225 Installation And Operation Instruction Manual

2.2.7 Button Functionality HM2236

2.2.8 Button Combinations HM 2236

Button Combination
Hold Gas+ and
press Stop
Hold Gas– and
press Stop
Hold K.Lösen and
press Gas+/-
Hold Hupe and
press Gas+/-
Hold Hupe and
press Stop
Hold Hupe and
press K.Lösen I
Hold Hupe and
press K.Lösen II
Hold Hupe and
press Ziehen
Hold Ziehen and
press Hupe
Button
Ziehen I
Ziehen II
K.Lösen I
K.Lösen II
Lösen I
Lösen II
Gas+
Gas -
Hupe
Stop
Combination Functionality
Switches the receiver unit from standby mode to active mode,
enabling the control output voltage. The red LED will illuminate
Switches the receiver completely off
(please use this function only if the engine is switched off)
Adjusts the brake release interval of K.Lösen
(depends on DIL-Switch 6 - see section 4.6)
Adjusts the ON/OFF-times of the brake release interval of
K.Lösen (depends on DIL-Switch 6 - see section 4.6)
Initiates an emergency alarm
(The external emergency call signal is triggered)
Switch-over 1./2. gear of the winch in standby mode
(release Ziehen before Hupe)
Switch-over 1./2. gear of the winch during pulling
(release Ziehen before Hupe)
Button Functionality
Push lever up, winch 1 or 2
pulls in cable
Controlled brake release
(see DIL switch pos. section 4.6)
Pull lever down, brake 1 or
brake 2 is released
The accelerator actuator pushes out
the compression pump lever
(see DIL switch pos. section 4.6)
The accelerator actuator pulls in the
compression pump lever
Sounds the vehicle horn
switches to standby mode, when
the receiver is in the active mode
red LED will extinguish
green LED will light
Engine Start
Engine Stop
9