Button Functionality Hm2226; Button Combinations Hm 2226 - HM-Funktechnik HM 2225 Installation And Operation Instruction Manual

2.2.3 Button Functionality HM2226

2.2.4 Button Combinations HM 2226

Button Combination
Hold Gas+ and
press Stop
Hold Gas– and
press Stop
Hold K.Lösen and
press Gas+/-
Hold Hupe and
press Gas+/-
Hold Hupe and
press Stop
Hold Hupe and
press K.Lösen I
Hold Hupe and
press K.Lösen II
Hold Hupe and
press Ziehen
Hold Ziehen and
press Hupe
Button
Ziehen I
K.Lösen I
Lösen I
Gas+
Gas -
Hupe
Stop
Combination Functionality
Switches the receiver unit from standby mode to active mode,
enabling the control output voltage. The red LED will illuminate
Switches the receiver completely off
(please use this function only if the engine is switched off)
Adjusts the brake release interval of K.Lösen
(depends on DIL-Switch 6 - see section 4.6)
Adjusts the ON/OFF-times of the brake release interval of
K.Lösen (depends on DIL-Switch 6 - see section 4.6)
Initiates an emergency alarm
(The external emergency call signal is triggered)
Switch-over 1./2. gear of the winch in standby mode
(release Ziehen before Hupe)
Switch-over 1./2. gear of the winch during pulling
(release Ziehen before Hupe)
Button Functionality
The winch pulls in cable
(only winch 1)
Controlled brake release winch 1
(see DIL switch pos. section 4.6)
Brake is released
(only winch 1)
The accelerator actuator pushes
out the compression pump lever
(see DIL switch pos. section 4.6)
The accelerator actuator pulls in
the compression pump lever
Sounds the vehicle horn
When the receiver is in the active
mode, switches to standby mode
(see section 4.2) Red LED will
extinguish, green LED will light.
Engine Start
Engine Stop
7