Crow Power Wave 8 User Manual page 3

OUTPUTS:
Output 1 _____________________
Output 2 _____________________
Output 3 _____________________
Output 4 _____________________
Siren Time: ____ (minutes)
COMMUNICATION OPTIONS:
Monitoring Domestic
SERVICING:
Can your system be serviced by another technician?
If yes, Installer Code __________
SERVICING NOTES:
Please contact your alarm installer if you require further information.
PDF created with FinePrint pdfFactory trial version
Speech
Yes No
http://www.fineprint.com
The CONTROL Key
Another special key that can be programmed to control a number of
functions.
1) Chime Zone Control: A Chime Zone is a detector that can be part
armed while you are home but working in another part of the building. It
can be programmed to operate a buzzer or light to let you know you have
a visitor.
Press the [CONTROL] key
(Program and System LED's will be on steady).
Press the [PROGRAM] key
(Program LED will flash)
indicating that Chime Zone is disabled.
To enable Chime Zone
Press <CONTROL> and <PROGRAM> key again.
Note: When the system is armed it changes to become a full alarm zone.
2) Output Control: Outputs are programmable contacts on the panel that
can be used to switch power or external devices on or off.
Press the [CONTROL] key
(Program and System LED's will be on steady).
Press the number key corresponding to the output you wish to turn on i.e.-
output 3 turns on water heating. Press the 3 key the 3 LED will illuminate
indicating the output is on. Press the [ENTER] key to return to normal
keypad function. To check what outputs are on simply press the
[CONTROL] key again, LED 3 will be illuminated pressing the 3 key again
will toggle the output off. Press [ENTER] to return keypad to normal.
The STAY Key
'Stay' mode allows you to monitor areas you will not be in at night. Pre-
selected zones or sensors can be armed with this key while you are in the
building and programmed to go into your choice of alarm states if
triggered. As with everything else on the panel this too can be tailored to
your needs. For example you may wish to have the detectors in your
garage and lounge sound only a little buzzer by your bed at night to warn
you of an intruder.
To use this feature press the [STAY] key and if programmed to do so, the
exit delay will sound. The armed light on the keypad will flash.