Ignition Circuit; Continuity Check - PIAGGIO Fly Workshop Manual

Fly

Ignition circuit

1) Check the state of the spark plug (clean it with
a metallic brush, remove all incrustations, blow it
with compressed air, and replace it if necessary).
2) Without removing the stator, perform the checks
described below:
After a visual inspection of the electrical connec-
tions, carry out the measurements on the charging
coil and pick-up (see table), and check for con-
tinuity using the special tester, 020331Y.
If the continuity checks or the inspections on the
coil and pick-up are incorrect, proceed by replac-
ing the stator, otherwise replace the ECU.
Remember to detach the ECU wirings when the
engine is not running.
Specific tooling
020331Y Digital multimeter
1 Red cable (1) and White cable (2)
1 Red cable (3) and Green cable (4)
1
2
P - U C
ICK P
Specification
R
ECHARGING COIL CHECK
Specification
C
ONTINUITY CHECK
Specification
White cable - Engine
White cable - Frame
(F A)
HECK IGURE
(F B)
IGURE
800 ÷ 1100 Ohm
Electrical system
Desc./Quantity
90 ÷ 140 Ohm
Desc./Quantity
Desc./Quantity
Continuity
Continuity
ELE SYS - 51