Solve Problems - walimex power shooter 600 Instruction Manual

Table of Contents

Advertisement

Available languages

Available languages

12. Solve problems

Problem
Flash device is
switched on, but has
no function
Flash shows functions,
but flash triggering not
possible
LC Display shows E0
LC Display shows E1
LC Display shows E2
LC Display shows E3
LC Display shows
Possible reason
The powerpack is not
or only insufficiently
charged/defect.
The fuse is defective.
Battery pack or flash
unit defective.
Flash pipe burned
through.
Problem with operation
temperature
No further triggering
possible, cycles .
System overheating.
Internal voltage inside
the flash is too high
Overload indication,
flash cycles become
slower and slower.
Remedy
Charge the powerpack/
replace the powerpack.
Replace the fuse, see
"Replacing the fuse".
Contact our service
department
If necessary have the
flash tube replaced by
a skilled electrician.
Contact our service
department
Contact our service
department
Switch off the device
for approx. 10 minutes.
Danger of overloading
Contact our service
department
Switch off the device
for approx. 10 minutes.
Danger of overloading
41

Advertisement

Table of Contents
loading

Table of Contents