[Connection Example] - Panasonic WV-NP1000 Operating Instructions Manual

[Connection example]

When connecting with a PC directly
(The illustration above is of the WV-NP1004.)
<Required cable>
LAN cable (category 5, cross)
When connecting via a network
(The illustration above is of the WV-NP1004.)
<Required hardware>
Switching hub or router
<Required cable>
LAN cable (category 5, straight)
Important:
• Use a switching hub or a router which is compliant with 10BASE-T/100BASE-TX.
• Power supply is required for each network camera.
• When connecting multiple network cameras, it is necessary to configure the settings of the broadband router in use. It is
also necessary to configure port numbers for each network camera independently. Refer to page 22 for further information
about the settings.
Refer to the operating instructions of the broadband router for descriptions of how to configure the broadband router.
16
AC24V
IN
VIDEO OUT
1-L
POWER
2-N
1 GND
SD CARD
2 DAY/NIGHT IN
3 AUX OUT
4 ALARM OUT
LINK
5 ALARM IN
GND
1
2
10BASE-T/
3
100BASE-TX
4
5
ACT
AC24V
IN
VIDEO OUT
1-L
POWER
2-N
SD CARD 1 GND
2 DAY/NIGHT IN
3 AUX OUT
4 ALARM OUT
LINK
5 ALARM IN
GND
1
2
10BASE-T/
3
100BASE-TX
4
5
ACT
Network device
(Hub, router, ADSL/CATV
modem, etc.)
LAN/Internet
LAN cable (category 5, cross)
System device
Connect to the video input connector of a frame
switcher, matrix switcher, etc.
Video monitor
Note: When connecting to the
Recording device
Connect to the video input connector of a digital
disk recorder, time lapse VCR, etc.
PC
video input connector of a
device that has the power
switch for the connected
camera, such as the
Panasonic WV-CM142,
turn the power switch for
the connected camera off.
PC (Refer to page 7 for the
system requirements for a PC)