Step 4 Settings - Panasonic SC-HT17 Operating Instructions Manual

4
Settings
Step
Change the settings to suit your equipment to the environment in which you are using it. Before making any changes, read the
descriptions of the settings, note the factory settings and ranges, and refer to the equipment's instructions.
DISTANCE See below
è
D-INPUT See below
è
Switch on.
DISTANCE
Enter the distance of the front, center and surround speakers
from the seating position.
The factory settings are:
FRONT:
CENTER:
SURROUND:
1
Enter the setup mode.
TUNE
2 2
Press at the same time.
2
Select "DISTANCE".
INPUT SELECTOR
3
Select the speaker.
MENU
4
Change the setting.
TUNE
2
2
OR
Repeat steps 3 and 4
5
Exit the setup mode.
TUNE
2
2
Press at the same time.
TUNE
INPUT SELECTOR
2
INPUT SELECTOR 2 TUNE 2 MENU
3.0 m
3.0 m
1.5 m
SETUP
DISTANCE
DISTANCE DR COMP
D-INPUT A/D ATT
FRONT
FRONT CENTER
SURROUND
3.0 m
1.0 m 10.0 m
COMPLETE
DR COMP See page 21
è
A/D ATT See page 21
è
MENU
2
%DIGITAL %PL
H. BASS
D-INPUT (digital input)
Change the setting for the DIGITAL IN terminals (OPT1, OPT2,
COAXIAL) on the rear of the unit if the equipment you have
connected is different to that labelled.
The factory settings are:
TV:
DVR:
DVD:
1
Enter the setup mode.
TUNE
2 2
Press at the same time.
2
Select "D-INPUT".
INPUT SELECTOR
3
Select the input position.
MENU
4
Change the setting.
TUNE
2
2
OR
Repeat steps 3 and 4
5
Exit the setup mode.
TUNE
2
2
Press at the same time.
Note
You can allocate only one piece of equipment per terminal. So
for example if you change "TV" from "OPT1" to "OPT2", "DVR"
will automatically switch to "OPT1".
VOLUME
DOWN UP
PHONES
OPT1
OPT2
COAX
SETUP
D-INPUT
DISTANCE DR COMP
D-INPUT A/D ATT
TV
TV DVR DVD
OPT 1
OPT 1 OPT 2 COAX
COMPLETE
13