XPLORE TECHNOLOGIES iX104 User Handbook Manual page 89

Table 8 Troubleshooting (continued)
Problem
Headphone or speaker volume is
too low.
An external device is not working
with the computer.
The Status LED is red, continuous.
The Status LED is red, blinking.
iX104 User's Handbook
Possible cause and solution
• The volume may be in Mute mode or set too low. Follow the
instructions in "Adjusting headphone or speaker volume" on
page 53.
• Make sure the volume control in your audio software is set to
an audible level.
The device may need to be enabled in the computer's
configuration program (BIOS Setup). Contact your local help
desk or reseller.
• The computer is on, running under battery power, and the
charge level in the battery has reached a critical level. Plug
the computer into an AC/DC power source or install a
charged battery.
• The system has encountered a fault and is preventing
normal operation. Contact your local help desk.
The computer is powered on, running under battery power,
and the charge level in the battery is at a minimum warning
level. Plug the computer into an AC/DC power source or install
a charged battery.
Appendix A. Troubleshooting
89