Using The 5 Ghz Band For Wds Links; Configuration Considerations - HP M210 Configuration And Administration Manual

Using the 5 GHz band for WDS links

When the M210 uses WDS only to extend the network by providing a dedicated link to
another M210 (that is, it does not simultaneously act as an AP for wireless clients), it is
recommended that, whenever possible, the WDS links use 802.1 1n or 802.1 1a in the 5 GHz
band. This optimizes throughput and reduces the potential for interference, as follows:
•
Most Wi-Fi clients support 802.1 1b or b/g; therefore, most APs are set to operate in the
2.4 GHz band. This frees the 5 GHz band for other applications such as WDS.
•
802.1 1a and 802.1 1n channels in the 5 GHz band are non-overlapping.
•
Assuming an optimal implementation, 802.1 1a supports up to 54 Mbps and 802.1 1n
supports up to 300 Mbps, providing a fat pipe for traffic exchange.

Configuration considerations

The following guidelines apply when you create a WDS link between two or more M210s:
•
The 5 GHz band has a shorter reach when compared to the 2.4 GHz band. This could be
a factor depending on the distance your WDS link span.
•
All radios must be set to the same operating frequency and channel. This means that on the
Wireless > Radio page under Channel, you cannot select Auto.
•
The Ethernet ports for all M210s must be connected to the same subnet, and each M210
must have a unique IP address.
•
If WPA (PSK) security is enabled, the same link name and key must be defined on all
M210s that are linked by the WDS connection.
•
IEEE 802.1 1n uses frame aggregation, whereby multiple frames are combined into one to
reduce overhead and increase throughput. WEP-encrypted frames are not aggregated,
however, so enabling WEP security over WDS will result in reduced throughput.
•
Although the M210 can support up to four WDS links, only one wireless link can be
defined between any two M210s.
68 Creating WDS links